NAMEwinbond-diag - EEPROM setup and diagnostic program for Winbond w89c840 based Ethernet cards.
DESCRIPTIONwinbond-diag is a program that you can use to diagnose problems with Ethernet cards based on the Winbond w89c840 chip.
OPTIONSThese programs follow the usual GNU command line syntax, with long options starting with two dashes ('-'). A summary of options is included below. -h, --help Show summary of options. -V, --version Show version of program. -v, --verbose Verbose mode. -q, --quiet Be very unverbose. -# <cardnum> Use card number <cardnum>. -a, --show_all_registers Print all registers. -e, --show-eeprom Dump EEPROM contents to stdout. -E, --emergency-rewrite Re-write a corrupted EEPROM. -p, --base-address <port> Specify port to use. -A, --Advertise <mediaype> Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD. -F, --new-interface <interface> Interface number. Options that make sense are: 10baseT, 10base2, AUI, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII and Autosense. -H, --new-hwaddress <address> Set card to a new hardware address. -m, --show-mii Dump MII management registers. -R, --reset Reset the transceiver. -T, --test Do register and SRAM test. -w, --write-EEPROM <values> Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do! -f, --force-detection Try to identify the card, even if it is active. -t, --chip-type <card> Explicitly set the chip. To get all valid numbers, run winbond- diag with the options '-t -1'.
AUTHORwinbond-diag was written and is still maintained by Donald Becker <email@example.com>. This manual page was written by Alain Schroeder <firstname.lastname@example.org>, for the Debian GNU/Linux system (but may be used by others). February 18, 2002 WINBOND-DIAG(8)