go to
> wackamole(8)
> wackamole.conf(5)
Homepage > Man Pages > Category > Maintenance Commands
Homepage > Man Pages > Name > W


man page of wackatrl

wackatrl: IP-failover high-availability controller

wackatrl - IP-failover high-availability controller
wackatrl [-c config_file ] [ -l | -f | -s ]


wackatrl runs the wackatrl IP-failover HA controller and instructs the currently running Wackamole instance to perform an action or display state information.


-c config-file Use an alternate configuration file config-file instead of wackamole.conf. -l Lists the current state (ownership) of virtual interfaces. -f Simulate a failure. The local instance will disconnect from Spread and act as if it has failed by dropping its managed interfaces and running whatever dynamic calls have been configured. A peer, should one exist, will assume the responsibility for the interfaces that were dropped. -s Recover from a simulated failure. This will tell the local instance to stop simulating failure. The local instance will reconnect to Spread and once again participate in the peer-based HA environment.


wackamole.conf The default config file location is dependant on the install prefix. ./wackamole.conf is also searched if a local file is not found.


All error messages, should any be produced will be written to standard error.
No known bugs.
Theo Schlossnagle <jesus@cnds.jhu.edu>


wackamole(8),wackamole.conf(5) WACKATRL(8)

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 28.82ms.

doomsdaydude.com | Ermitteln Sie Ihre IP-Adresse schnell und einfach | www.daelim-forum.com