go to
> nbp(1)
> pap(1)
Homepage > Man Pages > Category > Maintenance Commands
Homepage > Man Pages > Name > P


man page of papstatus

papstatus: get the status of an AppleTalk-connected printer


papstatus - get the status of an AppleTalk-connected printer


/usr/sbin/papstatus [-d] [-p printer] [retrytime]
papstatus is used to obtain the current status message from an AppleTalk connected printer. It uses the Printer Access Protocol (PAP) to obtain the status information. If no printer is specified on the command line, papstatus looks for a file called .paprc in the current directory and reads it to obtain the name of a printer. The .paprc file should contain a single line of the form object:type@zone where each of object, :type, and @zone are optional. type and zone must be proceeded by ':' and '@' respectively. Blank lines and lines the begin with a '#' are ignored. type and zone default to LaserWriter and the zone of the local host, respectively.
-d Turns on a debugging mode that prints some extra information to standard error. -p printer Get status from printer (do not consult any .paprc files to find a printer name). The syntax for printer is the same as discussed above for the .paprc file. retrytime Normally, papstatus only gets the status from the printer once. If retrytime is specified, the status is obtained repeatedly, with a sleep of retrytime seconds between inquiring the printer.


.paprc file that contains printer name


nbp(1), pap(1) PAPSTATUS(8)

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 30.71ms.

dfptutorial.com | doomsdaydude.com | autoresponder.name