go to
> nutupsdrv(8)
Homepage > Man Pages > Category > Maintenance Commands
Homepage > Man Pages > Name > O

oneac

man page of oneac

oneac: Driver for Oneac UPS equipment

NAME
oneac - Driver for oneac UPS equipment
NOTE
This man page only documents the hardware-specific features of the oneac driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

This driver supports Oneac EG and ON UPS equipment with the Advanced Interface. If your UPS is equipped with the Basic Interface card, use the genericups driver.

EXTRA ARGUMENTS

This driver supports the following optional settings in the ups.conf(5) file: testtime=num Change battery test time from the 2 minute default.

INSTANT COMMANDS

This driver supports the following Instant Commands. reset.input.minmax Reset the minimum and maximum input line voltage values seen since the last reset or power on. test.battery.start Start a battery test. The default time is 2 minutes. This time can be set in the ups.conf file. See testime above. test.battery.stop Stops a battery test that is in progress. test.failure.start Starts a 15 second long simulation of an input power failure.

AUTHOR

Eric Lawson <elawson@inficad.com>
SEE ALSO
The core driver: nutupsdrv(8) Internet resources: The NUT (Network UPS Tools) home page: //www.networkupstools.org/ ONEAC(8)
 
 
 

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 29.05ms.

brauche-versicherung.com - kurz und gut | brieftaubenversteigerung.com | plr.li