go to
> lmbench(8)
Homepage > Man Pages > Category > Maintenance Commands
Homepage > Man Pages > Name > B


man page of bw_pipe

bw_pipe: time data movement through pipes


bw_pipe - time data movement through pipes


bw_pipe [ -m <message size> ] [ -M <total bytes> ] [ -P <parallelism> ] [ -W <warmups> ] [ -N <repetitions> ]


bw_pipe creates a Unix pipe between two processes and moves total bytes through the pipe in message size chunks (note that pipes are typically sized smaller than that). The default total bytes is 10MB and the default message size is 64KB.
Output format is "Pipe bandwidth: %0.2f MB/sec\n", megabytes_per_second, i.e., Pipe bandwidth: 4.87 MB/sec
This benchmark can move up to six times the requested memory per process. There are two processes, the sender and the receiver. Most Unix systems implement the read/write system calls as a bcopy from/to kernel space to/from user space. Bcopy will use 2-3 times as much memory bandwidth: there is one read from the source and a write to the destionation. The write usually results in a cache line read and then a write back of the cache line at some later point. Memory utilization might be reduced by 1/3 if the processor architecture implemented "load cache line" and "store cache line" instructions (as well as getcachelinesize).


Funding for the development of this tool was provided by Sun Microsystems Computer Corporation.




Carl Staelin and Larry McVoy Comments, suggestions, and bug reports are always welcome. (c)1994 Larry McVoy $Date$ BW_PIPE(8)

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 31.85ms.

Ermitteln Sie Ihre IP-Adresse schnell und einfach | www.daelim-forum.com | Website Promotion