go to
> mii-diag(8)
Homepage > Man Pages > Category > Maintenance Commands
Homepage > Man Pages > Name > A

al1700-diag

man page of al1700-diag

al1700-diag: Diagnostic program for the Allied Telesis AT1700

NAME
al1700-diag - Diagnostic program for the Allied Telesis AT1700

SYNOPSIS

al1700-diag [options]

DESCRIPTION

al1700-diag is a diagnostic program for the Allied Telesis AT1700, and similar boards built around the Fujitsu MB86965. It does not test every possible hardware fault, but it does verify the basic functionality ofthe board.

OPTIONS

These programs follow the usual GNU command line syntax, with long options starting with two dashes ('-'). A summary of options is included below. -h, --help Show summary of options. -V, --version Show version of program. -v, --verbose Verbose mode. -q, --quiet Be very unverbose. -a, --all Print all registers. -e, --show-eeprom Dump EEPROM contents to stdout. -p, --base-address <port> Specify port to use. -F, --new-interface <interface> Interface number. Options that make sense are: 10baseT, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII and Autosense. -P <address> Set card to a new IO base address. -Q <irq> Set card to a new IRQ. -m, --show-mii Dump MII management registers. -r, --reset-ASIC Reset the ASIC. -m Tests multicast. -w, --write-EEPROM <values> Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!

SEE ALSO

mii-diag(8)
AUTHOR
This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others). February 23, 2001 AL1700-DIAG(8)
 
 
 

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 24.49ms.

information-information.de | brauchbar.de | plr.li