go to
> amanda(8)
> amanda-changers(7)
> amanda-taperscan(7)
> amanda-devices(7)
Homepage > Man Pages > Category > Maintenance Commands
Homepage > Man Pages > Name > A

amtape

man page of amtape

amtape: Control Amanda changers

NAME
amtape - Control Amanda changers

SYNOPSIS

amtape [-o configoption...] config subcommand [subcommand_options...]

DESCRIPTION

Amtape is the command-line interface to Amanda's tape changers (amanda- changers(7)) and to the taperscan algorithm (amanda-taperscan(7)). Tape changers maintain a notion of the current slot for each configuration. This may or may not correspond to an actual physical state of the device, but is used by some taperscan algorithms to minimize searching through the slots. Amtape uses the default changer. To use a different changer, use the config override option, e.g., -otpchanger=otherchanger.

SUBCOMMANDS

label label Search for and load the Amanda tape with label [label], also setting the current slot. slot slot Load the volume in the given slot, also setting the current slot. The slot names current, next, first, and last have special meaning. current Shorthand for slot current. inventory Show the contents of all slots, based on the changer's cached metadata. This is a quick operation as it does not load or unload any volumes, but is not supported by all changers. show Show the contents of all slots by loading each slot and reading its label. This can be very slow. reset Reset the changer to a known state. This subcommand is intended to clear any unknown and potentially incorrect state the changer may have stored. eject [drive] Eject the tape currently in the drive. This only applies to some changers. Specify a drive (by drive number) if more than one drive is available. clean [drive] If a cleaning tape is defined for the changer, used it to clean the specified drive. The [drive] is optional if the changer only has one drive. taper Run the taperscan algorithm (see amanda-taperscan(7)), displaying information about the progress of the scan. update [what] Update changer state. Consult amanda-changers(7) for changer-specific details on the format of what. -o configoption See the "CONFIGURATION OVERRIDE" section in amanda(8).

SEE ALSO

amanda(8), amanda-changers(7), amanda-taperscan(7), amanda-devices(7) The Amanda Wiki: : //wiki.zmanda.com/
AUTHORS
Dustin J. Mitchell <dustin@zmanda.com> Zmanda, Inc. (//www.zmanda.com) James da Silva <jds@amanda.org> Stefan G. Weichinger <sgw@amanda.org> AMTAPE(8)
 
 
 

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 23.38ms.

autoresponder.name | www.daelim-forum.com | elternfragen.net