go to
> el3diag(8)
Homepage > Man Pages > Category > Maintenance Commands
Homepage > Man Pages > Name > Other


man page of 3c5x9setup

3c5x9setup: setup program for the 3Com 3x9 cards.


3c5x9setup - setup program for the 3Com 3x9 cards.


3c5x9setup [options]


3c5x9setup is a program that you can use to setup 3Com 3c5x9 series ethercards.
These programs follow the usual GNU command line syntax, with long options starting with two dashes ('-'). A summary of options is included below. -h, --help Show summary of options. -v, --version Show version of program. -V, --verbose Verbose mode -D, --debug Show Debug messages -a, --all Print all registers -p, --base-address <port> Specify port to use -E, --emergency-rewrite Re-write a corrupted EEPROM -f, --force-detection Force if card is busy -F, --new-interface <type> Interface type to be used. This can be 10baseT, 10base2 or AUI. -P, --new-IOaddress, --new-base-address <port> New base I/O address -H, --new-hwaddress <addr> New base hardware address -Q, --new-irq <irq> Specify interrupt number -w, --write-EEPROM <values> Write to the EEPROMS with the specified values.


This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others). January 8, 2001 3C5X9SETUP(8)

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 48.01ms.

laufbaender.name | holzspalter.name | Reviews der besten Autoresponder