go to
> wicd(8)
> wicd-curses(8)
Homepage > Man Pages > Category > File Formats
Homepage > Man Pages > Name > W

wicd-manager-settings.conf

man page of wicd-manager-settings.conf

wicd-manager-settings.conf: contains settings that control Wicd's behavior

NAME
wicd-manager-settings.conf - contains settings that control Wicd's behavior
DESCRIPTION
This file contains general configuration information for Wicd. This file is located at /etc/wicd/manager-settings.conf

SETTINGS

link_detect_tool = <0|1|2> 0 = autodetect 1 = ethtool 2 = mii-tool flush_tool = <0|1|2> 0 = autodetect 1 = ip 2 = route backend = <ioctl|external> Default is ioctl backend. signal_display_type = <0|1> 0 = Show signal strength as a percentage 1 = Show signal strength in dBm dhcp_client = <0|1|2|3> 0 = autodetect 1 = dhclient 2 = dhcpcd 3 = pump sudo_app = <0|1|2|3> 0 = autodetect 1 = gksu 2 = kdesu 3 = ktsuss wired_interface = <interface_name> always_show_wired_interface = <True|False> wired_connect_mode = <0|1> 0 = connect to wired interface automatically 1 = do not connect to wired interface automatically prefer_wired = <True|False> True = Switch to wired interface if a link is detected, even if already connected to wireless False = Do not switch to wired interface automatically wireless_interface = <name_of_wireless_interface> wpa_driver = <wext|madwifi|ndiswrapper|hostap|hermes|atmel|broadcom|ipw|ralinklegacy> The default (and best supported) is wext. It should work properly in most cases. auto_reconnect = <True|False> This settings determines whether Wicd will attempt to reconnect on connection loss. use_global_dns = <True|False> If set to "True" and values are specified in the global DNS settings below, this will cause Wicd to use these DNS settings. global_dns_dom = <plaintext_domain_name> This specifies the default search domain to be used by the resolver. global_dns_1 = <ip_address> global_dns_2 = <ip_address> global_dns_3 = <ip_address> debug_mode = <integer_value> 0 = disabled 1 = enabled window_height = <integer_value> (in pixels) This determines the height of the client window. window_width = <integer_value> (in pixels) This determines the width of the client window. pref_height = <integer_value> (in pixels) This determines the height of the "Preferences" window when launched from the client. pref_width = <integer_value> (in pixels) This determines the width of the "Preferences" window when launched from the client.

SEE ALSO

wicd(8), wicd-curses(8), wicd-wired-settings.conf(5), wicd-wireless- settings.conf(5). wicd-1.7.0 WICD-MANAGER-SETTINGS.CONF(5)
 
 
 

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 23.49ms.

brieftauben-versteigerung.com | holzspalter.name | elternfragen.net