go to
> netgraph(4)
> ng_iface(4)
> ohci(4)
> uhci(4)
> usb(4)
Homepage > Man Pages > Category > Special Files
Homepage > Man Pages > Name > U

udbp

man page of udbp

udbp: USB Double Bulk Pipe driver

NAME

udbp - USB Double Bulk Pipe driver

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file: device udbp Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): udbp_load="YES"

DESCRIPTION

The udbp driver provides support for host-to-host cables that contain at least two bulk pipes (one for each direction), for example the EzLink cable and the NetChip 1080 chip. It requires netgraph(4) to be available. This can be done either by adding options NETGRAPH to your kernel configuration file, or alternatively loading netgraph(4) as a module, either from /boot/loader.conf or from the command line, before the udbp module.
EXAMPLES
options NETGRAPH device udbp Add the udbp driver to the kernel. kldload netgraph kldload udbp Load the netgraph(4) module and then the udbp driver. ngctl mkpeer udbp0: iface data inet ifconfig ng0 10.0.0.1 10.0.0.2 Create a new network interface node and connect its inet hook to the data hook of the udbp node. ifconfig(8) configures the resulting network interface ng0 with a local IP address of 10.0.0.1 and a remote IP address of 10.0.0.2. On the remote host, the two IP addresses should of course be reversed.
SEE ALSO
netgraph(4), ng_iface(4), ohci(4), uhci(4), usb(4), ngctl(8)

HISTORY

The udbp driver first appeared in FreeBSD 5.0.

AUTHORS

The udbp driver was written by Doug Ambrisko <ambrisko@whistle.com>, Julian Elischer <julian@FreeBSD.org> and Nick Hibma <n_hibma@FreeBSD.org>. This manual page was written by Nick Hibma <n_hibma@FreeBSD.org>. UDBP(4)
 
 
 

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 51.60ms.

wippsaege.name | generiere.de | Ausf├╝hrliches GetResponse Review