go to
> radiusd(8)
Homepage > Man Pages > Category > General Commands
Homepage > Man Pages > Name > R


man page of radrelay

radrelay: replicate accounting data to another RADIUS server


radrelay - replicate accounting data to another RADIUS server


radrelay [-P pidfile] [-a accounting_dir] [-d config_dir] [-f] [-i source_ip] [-s secret] server detailfile


Radrelay reads a file in the detail file format, reconstructs radius packets from it and sends them to a remote radius server. When end-of- file is reached, the file is truncated. Radrelay then waits until additional data to be written to the file, and starts over again.


-P pid_filename At startup, radrelay writes its process-id to a file. By default that is var/run/radrelay.pid, this option overrides that. -a accounting_directory The base directory to use to read the detail file from. -d config_directory The directory where the dictionary and clients files are. -f Do not fork and run in the background as a daemon. -i source_ip The source IP address to use for sending radius packets. -s secret Normally the secret for the remote server is looked up in /etc/raddb/clients. This option overrides the secret specified in that file. detailfile File to read the attribute/value pairs from. If this is not specified, they are read from stdin. server[:port] The hostname or IP address of the remote server. Optionally a UDP port can be specified. If no UDP port is specified, it is looked up in /etc/services. The service name looked for is radacct for accounting packets. If a service is not found in /etc/services, 1646 is used.
radiusd(8), doc/README.radrelay.
Miquel van Smoorenburg, miquels@cistron.nl. 22 November 2001 RADRELAY(1)

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 27.84ms.

wippsaege.name | elternfragen.net | plr.li