Homepage > Man Pages > Category > General Commands
Homepage > Man Pages > Name > I

icomlib

man page of icomlib

icomlib: programs to control Icom PCR-1000 receiver

NAME

icomlib - programs to control Icom PCR-1000 receiver

SYNOPSIS

pcr [options] [frequency | start_freq stop_freq freq_step] qpcr1k [options] [frequency | start_freq stop_freq freq_step]
DESCRIPTION
This manual page documents briefly the pcr and qpcr1k commands. This manual page was written for the Debian GNU/Linux distribution because the original program does not have a manual page. pcr is a console program, and qpcr1k is an X GUI program that controls an Icome PCR-1000 receiver. That receiver is designed to be controlled via a serial port connection.
OPTIONS
A summary of options is included below. -v <vol> Set volume, integer values from 0-99, default 70. -s Turn on scan mode -a Turn on AGC -n Turn on noise blanker -r Turn on RF Attenuator -h <holdpoint> Set hold point, integer 0-255, default 80 -w <wait> Set wait tme, positive integers, default 5 -t <sqtone> Set tone squelch frequency -q <squelch> Set squelch, integer 0-99, default 40 -f <bw> Set filter bandwidth, 3, 6, 15, 50, and 230, default 15 kHz -p <serial_port> Specify port the radio is attached to, default /dev/pcr1000 -u <logfile> Switch on unattended mode, using specified log file. -l <logfile> Switch on replay mode, using specified logfile -m <mode> Specify mode: LSB, USB, AM, CW, NFM, WFM These options may be followed by a frequency in MHz to tune the radio, or - if the scanning mode is set by the -s option, then start, stop frequencies in MHz and step frequency in kHZ must be specified.

EXAMPLES

Standard mode: pcr -p/dev/ttyS0 -v70 -q40 -f15 -mnfm -w10 146.52 Scanner mode: lower_freq = Lower frequency in megahertz upper_freq = Upper frequency in megahertz step_freq = Step frequency in kilohertz pcr -p/dev/ttyS0 -v70 -q40 -f15 -mnfm -h70 -u2m.log -s 144 148 5 Replay mode: <logfile> = File name of old log to replay pcr -p/dev/ttyS0 -v70 -q40 -f15 -mnfm -h70 -l 2m.log

SEE ALSO

pcrd(1), rx320(1). Other pacakges that can control the radio use hamlib: grip, sgcontrol, hamlib-utils. The programs are documented fully by icomlib-doc, available as a debian package.

AUTHOR

This manual page was written by Maitland Bottoms <bottoms@debian.org>, for the Debian GNU/Linux system (but may be used by others). January 7, 2001 ICOMLIB(1)
 
 
 

Copyright © 2011–2018 by topics-of-interest.com . All rights reserved. Hosted by all-inkl.
Contact · Imprint · Privacy

Page generated in 41.99ms.

brieftaubenversteigerung.com | get-ip.de | und-verkauft.de